Energy UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is designed solely to the smaller lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been extensively applied from the market of logistic devices like minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled by the solenoid valve together with the speed managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is designed solely for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the speed controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is reduce, the decreasing motion is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is developed solely for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve plus the speed controlled by a strain compensated movement management valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is created solely for that large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the pace controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the reducing motion is controlled through the manual override function.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic elements concerned ahead of installation of the power unit.
three. Viscosity with the oil shoud be 15~46 cst,which should also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
four. Oil changing is required just after the preliminary one hundred operation hours,afterwards the moment each and every 3000 hrs.
five. The electrical power unit proven is built to be mounted vertically.