Material Managing Electrical power UNIT 1
Standard Description
This energy unit is built for your fork lift market, consisting of really efficient gear pump, DC motor, manual increase and lower valve, tank, ect. The up and down motion are controlled from the lever of the guide release valve, and that is outfitted with an electric switch to activate the motor. The lowing velocity is controlled through the pressure compensated flow control valve.
Particular Notes
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean all of the hydraulic parts concerned ahead of installation of the power unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which must also be clean and cost-free of impurities, N46 hydraulic oil is advised .
four. Oil transforming is needed just after the original one hundred operation hrs, afterwards the moment each 3000 hrs.
five. The power unit proven is built to be mounted horizontally.

Materials Managing Power UNIT two
Basic Description
This energy unit characteristics power up gravity down circuit. Activate the start solenoid to start the motor to lift the machine. The lowing motion is activated by the solenoid valve with the reducing pace managed from the strain compensated flow control valve. Merchandise of this series could be extensively utilized in the market of logistic gadgets for instance fork lift, mini lift table, and so forth.
Unique Notes
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all the hydraulic elements concerned just before mounting the power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities, N46 hydraulic oil is suggested .
four. Oil modifying is needed immediately after the initial one hundred operation hours,afterwards the moment just about every 3000 hours.
5. The energy unit should be mounted horizontally.